Thermal Expansion Tank, what is it? How do I know if I need one? Why do I need one? Get ready to learn all you need to know about Thermal Expansion Tanks from your friends here at Emergency Plumbing Service.
In the past when hot water heaters needed to expand they would push water back into city water main lines. The problem with this is that it had a high risk of contaminating the main water supply. It wasn’t until around the year 1992 when the EPA started enforcing water providers protect their water supply. That is when water companies like Delaware City Water and Del-Co Water started putting on pit adapters and check valves (backflow prevention) making your water heater and house a closed loop system. When water companies started putting these check valves on homes Ohio passed the Thermal Expansion Code:
607.3.2 Backflow prevention device or check
Where a backflow prevention device, check valve or other device is installed on water supply system utilizing storage water heating equipment such that thermal expansion causes an increase in pressure, a device for controlling pressure shall be installed.
In layman’s terms, if you have a check valve device on your water supply then you need a Thermal Expansion tank. So if you have Del-Co Water or Delaware City Water you need an expansion tank. Does this mean the water companies going around house to house making sure everyone who is supposed to have an expansion tank has one? No, however, if you are remodeling or selling your home where you need a permit or have an inspection done a Thermal Expansion Tank WILL be required by the Building Department.
These check valves do such a great job that they create a thermal expansion in your hot water tank which is why you need a Thermal Expansion Tank. You see, pressure builds in all water systems because hot water expands and when it heats up the pressure inside main tank will be released over into the Thermal Expansion Tank until the pressure is normalized. If you do not have an Thermal Expansion Tank and you have a closed loop system (check valve) your T&P Valve will start to leak at around 150 PSI and 210*F to relieve the pressure. This kind of pressure build up could actually cause your water heater to explode. Also, if you do not have a Thermal Expansion Tank and you have a closed loop system you are putting added pressure on your entire plumbing system for example, your washer, toilet and dishwasher. Some warranties may actually be voided if there is a faulty or no Thermal Expansion Tank in place and you are required to have one due to your closed loop system. The Thermal Expansion Tank will add life to your water heater and your plumbing fixtures.
For optimal performance when installing a Thermal Expansion Tank it is important to match the water pressure coming into the house to the pressure in the Thermal Expansion Tank. Also, when mounting the Thermal Expansion Tank it should be mounted on the cold side between the water heater and the main water shut off valve. It is important to mount properly because if the tank fills with water it gets very heavy. A 2 gallon tank full of water is over 16lbs. That is a lot of weight hanging on a line, especially a CPVC line.
The size of the Thermal Expansion Tank you need is based on the size of your water heater(s). Examples for sizing in this area are: 52 G Water Heater or less = 2 G Thermal Expansion tank, 60 G Water Heater(s) or more = 4.5 G Thermal Expansion Tank. Depending on the quality of water a Thermal Expansion tank lasts an average of 5-8 years. Finally, testing your Thermal Expansion Tank is important and should be tested once a year when you flush your water heater. If your Thermal Expansion Tank is hanging from a pipe, you would push the Schrader Valve (air valve), located on bottom of the tank, if air is released then tank is working properly. If nothing or water comes out your tank is bad and needs replaced. If you have any questions regarding your Thermal Expansion Tank or would like to know if you need one give Emergency Plumbing Service a call at 740-548-5453.